<p>Single Nozzle Version found here: <a rel="nofollow" target="_blank" href="https://www.youmagine.com/designs/um2-dual-fan-shroud">https://www.youmagine.com/designs/um2-dual-fan-shroud</a></p><p>Disscussion about the fan shroud is found here:<a rel="nofollow" target="_blank" href="http://umforum.ultimaker.com/index.php?/topic/10554-um2-fan-shroud-replacement/?p=102188">http://umforum.ultimaker.com/index.php?/topic/10554-um2-fan-shroud-replacement/?p=102188</a><br></p><p>Please place comments in the discussion</p><p>Will require good insulation from the heater block and not recommended for high temp prints as it could deform. Working on a metal design.</p><p>Spacers are required to stop the hot end securing screws from hitting the shroud.</p><p>Make sure your temps arnt to high so overhangs are clean and the fit is correct. Can be printed with no infill.</p>
Creative Commons Attribution Share Alike