First appeared on Thingiverse by mnis, published May 5, 20183D printer parts and enhancements
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
This is a three-part object that can be simply plugged together and used without dismantling the printer components. The object is placed as an end piece on the printhead of the Ultimaker 2.
Stabilization of the two Bowden hoses and the wiring harness, fixation of the Bowden clips and the four long screws, dust protection.
So much for now ... This is just a first small step in a very specific direction. One thing is certain, a later extended version will serve a more useful purpose :-)
This item has not yet been printed and tested.
Depending on the print quality, some post-processing is required.
The object should be able to be easily pushed up if necessary and all three parts should fit well together. This must be checked before the final assembly, so that later can be worked only with little force on the print head.
During assembly, the right part must be attached first, then the left and finally the middle part.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.