Thanks for downloading!
We'd love to hear from you if the print was successful.
UM2 FanMount BLIZZARD
The BLIZZARD is a fanmount replacing the original one of the Ultimaker 2. First of all the BLIZZARD brings much more airfolw from the right fan. But also on the left side, the airflow is guided much more efficient to the nozzle. It reduces vibrations an noice.3D printer parts and enhancements
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
I was using the "Spirit Ultimaker 2 Fan Mount 2" myself. Lately my tempraturesensor lost contact to the heaterblock. So I had to disassamble the printhead. While remounting the Spirit fan mount i broke the holder. Searching for something new I found the "Laber um2-dual-fan-shroud".
I took the best ideas of both fan shrouds and designt my own "UM2 FanMount BLIZZARD". You can find more information in the PDF documentation.
I'm working on a version of BLIZZARD for the Olsson Block. Stay tuned.
Materials and methods
- 8x M3 screws 15mm-16mm
- 8x M3 nuts
- 8x Washer (only when using 16mm screws)
- Kapton tape
- Small piece of aluminiumpaper
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
i love this desig, works great. any update on the version for olsson block?
I like the idea of the internal guides to direct air and support the roof while printing it.
I'm wondering if the duct wouldn't work better if it were in two pieces, with no thin flat pieces joining the right and left fan ducts?
That would pretty much eliminate the parts that get overheated and tend to melt.