A spool holder that you can use on your lovely Ultimaker 2 that allows you use spools with a smaller hole! It has buit in support that should break away after printing, although I recommend using support (touching Builplate) anyway. I printed it at 0.1mm resolution and it it came out very nicely

Creative Commons Attribution Share Alike

Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.

Learn more or download attribution tags

Description

Documents

Comments

Leave a comment

Log in to leave a commentDon’t have an account yet? Sign up here!

Patrick Dukes added this to the Um2+ collection about 3 years ago

Nattaphong Sirisopanon added this to the will make (maybe) collection about 6 years ago

xile6 added this to the ultimaker collection almost 7 years ago

Joe Schepis printed this almost 7 years ago

Printed on:

Ultimaker 2+

Result:

Good design. But, this did not fit properly in my Ultimaker 2+ Extended. I had to trim the vertical walls on the hook end and the ridges on the front side. Also, the supporting structure was a little difficult to get out, but that is a CURA issue.

Feedback:

I printed with PLA with 0.2mm layer height. It came out well. [See attached suggestion. Email me for second suggestion.]

Frederiek Pascal commented about 7 years ago

Hey man, is it much work for you to create this model to fit the big colorfabb 2.2 kg spools? They are the same diameter as the normal spools (that's 5mm I think?) but they are 10 cm width...

thnx in advance :)

김인달 added this to the um2 collection about 7 years ago

Shari Tambasco added this to the Utilitarian collection about 7 years ago

AtomicBob published this design over 9 years ago