Thanks for downloading!
We'd love to hear from you if the print was successful.
Voronoi Filament Spool Holder
Voronoi Filament Spool Holder3D printer parts and enhancements
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
This large voronoi spool holder works with both Prusament 1KG spools and ColorFabb 750 gram spools (these are the spools I had to test). Other similar spools should work just fine too!
You'll need the following (3D-printed) parts:
- Base of the holder (1x)
- Rollers (2x)
- Pins (4x)
- 608ZZ bearings (4x): https://bit.ly/3dtoRHk (affiliate)
Assembly is quite simple. First you insert the four bearings into the two rollers. You then align the rollers in the base (one by one). Whilst holding the roller in position, press the pins through the base and into the rollers. Take a look at the cross section view to better understand what the end result should be. You shouldn't need any glue, as the pins have a press/interference/friction fit with the bearings. The same goes for the bearings and the rollers.
If you've used this holder with any spool other than the ones I've mentioned, please drop a comment so other people know what spools work :)
If you want to support me for the designs I publish for free, please consider using my AliExpress Affiliate Link (https://bit.ly/2XYWpHW) when buying something from AliExpress. It doesn't cost you anything extra, but helps me out a lot :)
Materials and methods
0.15mm - 0.20mm
ColorFabb & Prusament
Dutch Orange & Galaxy Black
PLA/PHA & PLA
Issues are used to track todos, bugs or requests. To get started, you could create an issue.