Thanks for downloading!
We'd love to hear from you if the print was successful.
Wavebreacher - 420mm Jetboat
This is the 2nd version of my 3d printed Jetboat.
Toys
Creative Commons Attribution Noncommercial Share Alike
Commercial use is not allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
Description
Version 2.0 "Wavebreacher" is out. Improved overall efficency!
The next version is already in progress. It will be a collaboration with Jotham B.
Feel free to join our Discord server:
and our facebook group:
Materials and methods
Materials and methods
Needed material
- about 400g of material of your choice (350g hull / + Jetpump and Impeller) Pla or Petg would be best
- 0.2 - 0.25 layerheight recommended. 20% infill "honeycomb"
- print at least with 2 perimeters
Once you printed all parts, you should glue the hull together, using some superglue.
A couple of m3 x6mm screws should lock the pump/nozzle in place
A m2.5 x5 mm screw (only for my motor. Just ask if you have any questions!)
Electronics:
1900 - 2200KV brushless inrunner motor the one I used: https://www.rc-raceboats-shop.de/lng/en/motoren/seriousrc-4-pol-motoren/seriousrc-28mm-motoren/src28606d-2100upmv.html?type=N&language=en
50 - 80 amps brushless ESC, depending on KV of the motor the one I would recommend: https://hobbyking.com/de_de/hobbyking-red-brick-2-7s-70a-esc-v2.html?queryID=9a5da3c65ca76e65c84c4a6f5c9d44b3&objectID=48606&indexName=hbk_live_magento_de_de_products
a 2s - 6s Lipo up to 2200mah, 2 would be best to not have an overweight on one side!
a 9g servo.
and of course a transmitter and a receiver
Bushings:
as the boat is really small, it only uses bushings wit an ID of 3mm OD of 4.5 and a length of 5mm
These are mine: https://www.igus.com/product/58
As rod, I advise a 3mm x 200mm Stainless Steel rod
To fit the impeller, you have to file a flat spot at the end of the rod and try to slide the Impeller on. It should have a thight fit.
As lid, there is no printable option yet. It`s just a selfmade lid of 2mm acrylic glass.
if you have anything to ask/say, feel free to use the comment section below!
Documents
Edit in 3dslashIssues
Issues are used to track todos, bugs or requests. To get started, you could create an issue.
