Wristball / Gyroball pull tab
A tab to make pulling the thread on a Wristball a bit easier.Other
Creative Commons Attribution Share Alike
Commercial use is allowed, you must attribute the creator, you may remix this work and the remixed work should be made available under this license.
A small tab 20 x 15 x 5mm for a Wristball thread.
It consists of two identical parts, that have a slot in between to fit a thread with a knot.
Parts are meant to be glued together with a super glue.
Materials and methods
Filament: PLA (sticks well with super glue)
Layer height: 0.2mm (nozzle 0.4mm)
Printing surface: glass
Print two identical parts.
Make a small knot at the end of a thread.
Don't apply super glue yet. Make sure the knot and the end of a thread fit nicely between parts when you press them together! Then apply the glue and press the parts together again.
Issues are used to track todos, bugs or requests. To get started, you could create an issue.