<span>this block makes adjusting the Z-level for the printbed endstop more accurate and stable<br><br><b>Instructions:</b><br><br></span>The stepfile includes the complete assembly for reference!<br><br>-Remove Z-endstop<br>-put in 3 nylock M3 nuts in the block according to the drawing.<br>-put the switch in the block <br>-take out the left Z-rod<br>-drill a hole in the top, you should measure the exact location<br>-put in a M3 x 30 or longer with a washer, then add a washer + nylock nut from inside to fix the long screw in vertical direction. Tighten until it still turns but not moves up and down.<br>-screw the switch to the backplate with 2 M3 x 20+2 washers, until it is fixed, but still able to move up and down<br>-place left Z-rod back<br>-screw the long M3 in the block to finetune Z-height.<br>-optional: Once adjusted, tighten the screws on the backplate
Creative Commons Attribution Share Alike
