Span2 nbkj7nef

Erick

Activity

Commented on Ultimaker 2 Coolboard Duct for Control Board Cooling over 5 years ago
J20 is always on, from what I remember the only pwm's are for the cooling fans and hot end. There may be a method of turning j20 on/off but I haven't looked into it any further, I can't hear the fan at all.
Commented on Ultimaker 2 Coolboard Duct for Control Board Cooling over 5 years ago
Blame auto-correct for any goofy looking typo's in that last response, LOL.
Commented on Ultimaker 2 Coolboard Duct for Control Board Cooling over 5 years ago
No problem. The fan doesn't add any noise at all from what I could tell, I sat infront of it for an hour during a print with no increase in noise. It may not be pushing as much air as a louder higher rpm fan might, but it's certainly better than what cooling the bird comes with. I started noticing browning around the solders for the xyz drive connections indicating some overheating. So is like anything that can help keep temps down during long prints. Enjoy :) - Erick
Commented on Ultimaker 2 Coolboard Duct for Control Board Cooling over 5 years ago
Here you go, this is the fan I'm using: 2 Pin Connector Brushless DC 24V 0.15A Turbo Blower Cooling Fan https://www.amazon.com/dp/B00H8VV0XK/ref=cm_sw_r_awd_c6pewb0NJCRBJ - Erick
Favored PP-2000 toy replica over 5 years ago
Contributed on UM2 Alt Filament Feeder Mechanism over 5 years ago
Carousel thumb dsc00560
Printed on:
Ultimaker - The Ultimaker 2
Commented on UM2 Alt Filament Feeder Mechanism over 5 years ago
Just wanted to thank you for this version! I know IRobertI's system seems highly favorited, but having the back plate holding the extruder motor makes yours a design on its own. Very tough and sturdy. To those who print this just make sure to print the arm at the highest infill you can, I did 100%.
Contributed on UM2 Alt Filament Feeder Mechanism over 5 years ago
Carousel thumb dsc00334
Printed on:
Ultimaker - The Ultimaker 2
Result:
Love it, I had a few hot end issues after installing this feeder system and it made that troubleshooting a breeze. Excellent design!
Updated Ultimaker 2 Compact Fan Ducts over 5 years ago
Updated Ultimaker 2 Compact Fan Ducts over 5 years ago
Updated Ultimaker 2 Compact Fan Ducts over 5 years ago
Published Ultimaker 2 Compact Fan Ducts over 5 years ago
Contributed on UM2 Alt Filament Feeder Mechanism over 5 years ago
Carousel thumb dsc00334
Printed on:
Ultimaker - The Ultimaker 2
Result:
Excellent! Very happy with this design, you thought it out well.
Published Nozzle Holder with Screw Hole over 5 years ago
Favored Nozzle holder over 5 years ago
Contributed on Nozzle holder over 5 years ago
Carousel thumb dsc00495
Printed on:
Ultimaker - The Ultimaker 2
Result:
Worked Great. Did a remix of it.