Span2 dim3nsioneer 3

Dim3nsioneer

  • Joined on Nov 26, 2013
  • Dim3nsioneer@gmx.ch
  • 68 times favorited
  • 7,881 times downloaded

Activity

Favored Ultimaker S5 axis alignment tool over 2 years ago
Published Swiss Ultibot over 4 years ago
Contributed on UM2 adjustable spring replacement over 4 years ago
Carousel thumb img 3162
Printed on:
Ultimaker 2
Result:
A perfectly fitting spacer - what else... ;-)
Published Body of iRoberti's feeder for 1.75mm over 4 years ago
Commented on Improved Snap On Guide for "|Robert|'s Alternative UM2 Feeder V2" almost 5 years ago
Doesn't work for me (cannot snap it onto the Robert feeder). Maybe I'm too stupid for it.
Commented on UM2 Printhead top for UMO+ about 5 years ago
@Meduza: I made a very dirty dual hack with OpenSCAD. I'll publish it here as soon as I'm sure it works.
Commented on UM2 Printhead top for UMO+ about 5 years ago
Very nicely constructed for being 3D printed. Do you happen to have a dual version?
Favored vacuum cleaner drill aid over 5 years ago
Updated Ultimaker Original Rod Spacer almost 6 years ago
Commented on Ultimaker Original Rod Spacer almost 6 years ago
<p>As I wrote, it was not my idea. Ultimaker introduced the concept with the UM2.</p>
Published Open Rod end cap for UMO almost 6 years ago
Published Ultimaker Original Rod Spacer almost 6 years ago
Commented on Bearing adapter for direct drive (UM Original) over 6 years ago
I added the original FreeCAD file...
Commented on Bearing adapter for direct drive (UM Original) over 6 years ago
It's open source...feel free to adapt the design... ;-) It shouldn't be very difficult to shorten it by 3mm... e.g. with Blender.
Commented on Alternative UM2 Feeder - version two over 6 years ago
I wasn't paying attention to how the top hole looked before I inserted the Bowden clip and the tube. The result is that the Bowden tube is stuck there forever; it doesn't come out again; most probably because the clip is still squeezed when pushed down as much as possible...
Commented on Star Wars Lightsaber (Normal version) over 6 years ago
I used 0.06mm layer height and got two layers which were out in the air.
Commented on Star Wars Lightsaber (Complex version) over 6 years ago
The force was definitively with you! Amazing! I'm just finishing the 4-piece version which I started at the beginning of this week. Guess what I'm going to print next... :-)