Span2 jochen gupf 2012

Jochen Hanselmann

Activity

Favored Spherium almost 6 years ago
Commented on Filament Clip 3mm or 1.75mm almost 7 years ago
Very nice and usefil design. I use it on all my filament spools. Many thanks for sharing. Actually the diameter of the hole was a little bit too tight for all of my 2.85mm filaments. The holding clip was ok. So I made a derivative on Tinkercad with 3.6mm hole diameter. https://tinkercad.com/things/emCI7OMkfl9
Favored Filament guide over 7 years ago
Commented on Calibrationpyramid Um1 Um2 Blau Mar14 Sm almost 8 years ago
Thanks @Jena. Actually the UM2 needed more than one hour vs. the UM1 only 30 min. Regarding quality: barely noticeable. On the UM2 the edges are a little bit sharper / finer. I needed to carefully adjust the temp. on both machines to reduce blobbing. But on both even with 205°C had some blobs.
Commented on Raspberry Pi Snap-fit Case almost 8 years ago
Many thanks @Kotzaak. Please let me know if you experience something else or have other improvement ideas. I think thinner walls would be sufficient. Will try when I find some time. In addition there may be better fittings. The current span fitting may wear off after a while (when opening and closing a lot of times) and not hold the two parts together sufficiently.
Updated Raspberry Pi Snap-fit Case almost 8 years ago
Commented on Raspberry Pi Snap-fit Case almost 8 years ago
v.133 widened the power plug slot to 9mm (w) x 6 mm (h). Position changed to 5.5mm from bottom. This was due to reports that sometimes the power plug didn't fit properly in the small slot.
Updated Raspberry Pi Snap-fit Case almost 8 years ago
Updated Raspberry Pi Snap-fit Case almost 8 years ago
Updated Raspberry Pi Snap-fit Case almost 8 years ago
Commented on Raspberry Pi Snap-fit Case about 8 years ago
Corrected holes for USB, Audio, RCA Video and Power
Updated Raspberry Pi Snap-fit Case about 8 years ago
Published Raspberry Pi Snap-fit Case about 8 years ago