Span2 erik sticker

Erik Cederberg

  • Ultimaker 2+
    Utm2 plus small

    Ultimaker 2+

    Ultimaker 2+ #1

    Ultimaker 2 upgraded to Ultimaker 2+, with custom print head parts, dual olsson blocks with 35W heaters for 2.85mm / 1.75mm filament and a E3D titan feeder for the 1.75mm side.

  • Ultimaker 2+
    Utm2 plus small

    Ultimaker 2+

    Ultimaker 2+ #2

    One of the first Ultimaker 2+, now fitted with a Bondtech DDG feeder.

  • Ultimaker 3
    Utm3 small

    Ultimaker 3

    Ultimaker 3

    My main prototyping printer

Activity

Commented on Protective Visor by 3DVerkstan 3 months ago
@exlink: 20 minutes is not really reasonable on a Ender 3 Pro. The hotend and feeder is not up to that kind of flow rate, i believe the fastest we were able to make our Ender-3's do reliably at Stockholm Makerspace were about 35 minutes each with 0.8mm nozzle, PLA and a higher temperature than usual. Our Ultimakers with 0.8mm nozzles were pushing them out in sub 20 minutes each all day. But to get closer to these numbers, you first need to change your nozzle to a .8mm. A larger nozzle is the single largest print time reducing measure you can do. A larger nozzle will make printing stacks harder though, and my recommendation is that you to print two at a time instead of stacking, it will give you better surface quality and a lower failure rate.
Updated Angle Gauge set 3 months ago
Updated Angle Gauge set 3 months ago
Updated Angle Gauge set 3 months ago
Updated Angle Gauge set 3 months ago
Updated Angle Gauge set 3 months ago
Updated Angle Gauge set 3 months ago
Updated Angle Gauge set 3 months ago
Updated Angle Gauge set 3 months ago
Published Angle Gauge set 3 months ago
Updated Ultimaker 3 Print Core Rack 3 months ago
Updated Ultimaker 3 Print Core Rack 3 months ago
Updated Ultimaker 3 Print Core Rack 3 months ago
Published Ultimaker 3 Print Core Rack 3 months ago