×Read this message from Erik, founder of YouMagine

Giuliano Mazzina

  • Joined on Jun 21, 2020
  • Unknown


Contributed on Hyphoon Herb Grinder about 2 years ago
Carousel thumb img 20200621 143056
Printed on:
prusa mk3
Fantastic. A couple spots that needed support were annoying to get cleaned up, but beyond that, the parts lined up perfectly. Can't wait to get some new flower and give this a whirl. Printed in PLA. Can confirm, the grinder cone does not touch the walls.
The drawer didn't fit at all. I had to file down some material on both the grinder and the drawer. But now it goes in and comes out properly with only a bit of force needed to take the drawer out all the way.