Hamdan

Joined on Jan 11, 2015
Unknown

Contact

Activity

Favored UM2 Bearing Filament Guide over 4 years ago

Favored Articulated Pringles can holder (Cantenna) almost 5 years ago

Favored Parametric Air Hose Flange over 5 years ago

Followed Ultimaker 2 upgrades! over 5 years ago

Favored Filament Fuser Block over 5 years ago

Favored Ultimaker2 Feet inc flexible base over 5 years ago

Favored ulti-foot over 5 years ago

Favored Apad almost 6 years ago

Favored Trichter für PET Flasche / Funnel for PET Bottle over 6 years ago

Favored Ducati 1199 Superbike (Complex) over 6 years ago

Favored Closed chamber ('green house') UM2 over 6 years ago

Favored Gear Cog Series - 5 Gears, 20 Ratio combinations over 6 years ago

Favored Simple test over 6 years ago

Favored Printed Brushless 36900rpm - Warning explosion problem about 7 years ago

Commented on Printed Brushless 36900rpm - Warning explosion problem about 7 years ago

I think even if you increase the thikness it will explode- this will only protect you from the magnet when it breaks up-the proplem is not in the frame thickness but in the strength of the support for the magnets and the shaft (the bearing adapter) maybe if you print it in ABS or higher strength material it will withstand the forces and be a success, Be carefull friend :) wear googles and good luck , I like the project.

Favored Alien Z Probe for 3d Printer about 7 years ago

Favored GoPro SeatPost Mount (25.4mm) about 7 years ago

Load more Back to top