Span2 pagan maze3  mobile

Dennis Preston

Activity

Commented on Filament Clip almost 5 years ago
I use 3mm (2.85) and the fit snug. Think they might be loose on 1.75mm.
Favored Filament Clip almost 5 years ago
Favored CABLE CLIP almost 5 years ago
Updated Bling Chain almost 5 years ago
Followed Helder L. Santos almost 5 years ago
Favored Plus Block almost 5 years ago
Favored ARM-OPO almost 5 years ago
Commented on OnePlus Stereo Sound Stand almost 5 years ago
This one's stl has the same dimensioning problem as the other design. It's about an inch. Checked in Cura ans Sketchup. Couldn't check the stp as my Solidworks crashed on it, but it could be at my end.
Commented on OnePlus Crab Stand almost 5 years ago
I loaded the stl into Cura, it will fit any phone whose longest dimension is 3/4 of an inch.
Favored Test your 3D printer! almost 5 years ago
Favored Overhang calibration almost 5 years ago
Commented on Recipe Cards & OnePlus Holder for Kitchen almost 5 years ago
Tasty and creative idea! Might have some overhang problems printing the "recipe" letters. They might work better as cutouts on the sides (like stencils).
Updated Bling Chain almost 5 years ago
Favored Bling Chain almost 5 years ago
Published Bling Chain almost 5 years ago
Contributed on The Gamester almost 5 years ago
Carousel thumb img 20150303 125106
Printed on:
ultimaker original
Result:
Printed slowly with a brim of 10 lines it comes out beautifully.
Feedback:
The Gamester being printed.