• Joined on Apr 01, 2014
  • Unknown
  • 91 times favorited
  • 13,952 times downloaded


Contributed on Runcam 2 - 25 Degree & 30 Degree Angled Protective Mount over 5 years ago
Carousel thumb img 2834 copy
Printed on:
This printed well in clear PETG on the Eustathios with .1mm layer height, .8mm shell, and 25% infill.
Updated Eustathios over 5 years ago
Commented on Eustathios about 7 years ago
<p>Cmolica,</p><p>The steppers I used were from a friend, but I believe these are the ones that I have:</p><p><a target="_blank" rel="nofollow" href="http://www.alltronics.com/cgi-bin/category.cgi?item=N1728S87">http://www.alltronics.com/cgi-bin/category.cgi?item=N1728S87</a><br></p><p>For the controller, I'm using a Rambo from Ultimachine:<br><a target="_blank" rel="nofollow" href="https://ultimachine.com/content/new-rambo-3d-printer-electronics-ultimachine">https://ultimachine.com/content/new-rambo-3d-printer-electronics-ultimachine</a><br></p><p><br></p><p>Also, check out the "Ingentis and Eustathios Builders Community" on Google+. &nbsp;There are plenty of folks on there willing to help:<br></p><p><a target="_blank" rel="nofollow" href="https://plus.google.com/u/0/communities/108524206628971601859">https://plus.google.com/u/0/communities/108524206628971601859</a><br></p><p><br></p><p>Good&nbsp;Luck!</p>
Commented on Eustathios over 7 years ago
Everton, thanks for the comment. I downloaded the Bearing Holder A and was able to slice it properly in Cura and Slic3r. In any case, the "A" bearing holder is just a mirror of "B", so feel free to flip it yourself. Which slicer are you using that is telling you the model is corrupt?
Updated Eustathios over 7 years ago
Favored Eustathios over 7 years ago
Commented on Eustathios over 7 years ago
Done! The v2.0 carriage is a vast improvement over the v1.0 design. It includes integrated fan ducts for the 30mm hotend fan as well as a 40mm cooling fan for the printed part. The compact design also allows for much greater travel along all 3 axes brining the build volume to 300mmx300mmx270mm. &nbsp;I would suggest printing with the rear as the base of the print and using a raft to support the raised portion.
Updated Eustathios over 7 years ago
Updated Eustathios over 7 years ago