Span2 looney tunes wile e coyote e1348175135982

Joe Schepis

  • Joined on Apr 06, 2016
  • Unknown


Contributed on UM2 Universal Spool Holder over 7 years ago
Carousel thumb slide1
Printed on:
Ultimaker 2+
Good design. But, this did not fit properly in my Ultimaker 2+ Extended. I had to trim the vertical walls on the hook end and the ridges on the front side. Also, the supporting structure was a little difficult to get out, but that is a CURA issue.
I printed with PLA with 0.2mm layer height. It came out well. [See attached suggestion. Email me for second suggestion.]