Bb75da4d7e6f900f5f6d759169083cb1?default=blank&size=170

Jotham B

  • Joined on Apr 04, 2018
  • Unknown
  • 102 times favorited
  • 31,067 times downloaded

Activity

Commented on Version 3: 3D printed Jetsprint jet boat almost 2 years ago
So what you can do is hook up the motor cooling and the ESC cooling to the same water loop - works just fine. It does have enough pressure to push it through. I don't need a very high flow rate I found since it doesn't heat much to begin with. Do post some pictures if you get it going! Would love to add them here with your permission.
Commented on Version 3: 3D printed Jetsprint jet boat almost 2 years ago
@kyle Wenner you'll want to print it with the rear of the boat facing downward so that the nose points up as it prints. I highly recommend you print it in sections and glue it together but as one piece should work too. Let me know how you get on.
Followed Reto M. almost 2 years ago
Commented on 3D printed Jet boat V2 about 2 years ago
Sure, I can send you the one in the photos, I don't use it anymore since I have a newer version I printed. Email me your details: jotham@simply3d.co.nz and at cost of postage I'll send it to ya. :-)
Commented on 3D printed Jet boat V2 about 2 years ago
I can't sorry. I'm in NZ it's a little bit far away!! You can buy a ender 3 3D printer for like about 200euro so that might be a good option for you.
Updated 3D printed Jet boat V2 about 2 years ago
Updated 3D printed Jet boat V2 about 2 years ago
Updated 3D printed Jetsprint jet boat V1 over 2 years ago
Updated 3D printed Jet boat V2 over 2 years ago
Updated 3D printed Jet boat V2 over 2 years ago