• Joined on Jun 24, 2014
  • Unknown
  • 1 times favorited
  • 457 times downloaded


Favored STAR, an Arduino Robot Recreation over 1 year ago
Published Mavic Pro strobe mount about 2 years ago
Published DJI Mavic Battery Modified Terminal cover almost 3 years ago
Contributed on DJI Mavic Battery Terminal cover almost 3 years ago
Carousel thumb img 3751
Printed on:
Ultimaker - The Ultimaker 2
Used 0.2mm layer height at 0.6mm nozzle for speed. Fits very nicely.
I later made a slight modification, 1mm less height and added two ears to make removement easier.
Favored Printed Boat 6 about 4 years ago
Commented on Alternative UM2 Feeder - version two about 4 years ago
After several hours of succesfull prints the filament starts to slip inwards from the bearing... :-( Happened after filament change. I am using the low friction spoolholder as well. Any ideas whats going wrong would be highly appreceated!