Span2 capture

Lars Karlslund

Activity

Published Two Bit MK8 Extruder V2 over 5 years ago
Published Miniature GT2 belt joiner over 5 years ago
Followed Felicity over 5 years ago
Updated Unwired Mini Kossel Effector V3 over 5 years ago
Favored Belt Tensioner, adjustable R3 almost 6 years ago
Updated Unwired Mini Kossel almost 6 years ago
Updated Unwired Mini Kossel almost 6 years ago
Commented on Two Bit MK8 Extruder almost 6 years ago
<p>Sorry, it does not fit a Mk7</p>
Commented on Unwired Mini Kossel Effector V3 almost 6 years ago
<p>Distance is 33.79mm ;)</p>
Commented on Unwired Mini Kossel almost 6 years ago
<p>I have uploaded Configuration.h and 20150430.epr. These are the configuration files for Repetier 0.92.3 (upload to <a rel="nofollow" target="_blank" href="http://www.repetier.com/firmware/v092/">http://www.repetier.com/firmware/v092/</a>&nbsp;and&nbsp;adjust)&nbsp;and&nbsp;my&nbsp;EEPROM&nbsp;dump&nbsp;from&nbsp;a&nbsp;couple&nbsp;of&nbsp;days&nbsp;ago.&nbsp;YMMV,&nbsp;but&nbsp;you&nbsp;can&nbsp;start&nbsp;with that.</p>
Favored Pocket Ratchet Wrench almost 6 years ago
Favored R2-D2 almost 6 years ago
Published Unwired Mini Kossel Effector V3 almost 6 years ago
Updated Unwired Mini Kossel almost 6 years ago
Updated Unwired Mini Kossel almost 6 years ago
Updated Unwired Mini Kossel almost 6 years ago
Commented on Unwired Mini Kossel almost 6 years ago
<p>Thank you. It did come out quite well. There are three parts that need an update: upper corner, lower corner (they need holes for wires in both sides, and bigger hole size). Also I think the parts for connecting the rails to the arms could be improved, I haven't drawn them up yet, but will do it, now that you mention you wish to build this.</p><p>Also I have made an experimental effector, using two fans. One fan cools the E3D hotend all the time, and blows most of the air through the other fan when that is powered off. When you want to cool your print, the second fan turns on, and both fans blow into the effector, forcing the air out through 20 ducts in the bottom of the effector. You have to see it to understand it, I think. I posted about it here (it's in&nbsp;Danish, sorry,&nbsp;but&nbsp;you&nbsp;can see&nbsp;the&nbsp;pictures):</p><p><a rel="nofollow" target="_blank" href="https://www.facebook.com/groups/3dprinter/permalink/1089354857746409/">https://www.facebook.com/groups/3dprinter/permalink/1089354857746409/</a></p>
Updated Unwired Mini Kossel almost 6 years ago