Span2 looking4 logo 256x256

Looking4

  • Joined on Dec 21, 2014
  • Unknown
  • 113 times favorited
  • 21,387 times downloaded
  • Ultimaker 2+
    Utm2 plus small

    Ultimaker 2+

    Ultimaker 2

Activity

Updated Housingcover Ultimaker 2 about 1 month ago
Updated Housingcover Ultimaker 2 about 1 month ago
Updated Bavarian Mask about 1 month ago
Published Rift S audiostrap GT air about 1 month ago
Published Rift S audiostrap GT air about 1 month ago
Commented on Bavarian Mask about 1 year ago
Uploaded Modells with planned support for BavarianMask M, S and 2F.
Updated Bavarian Mask about 1 year ago
Updated Bavarian Mask about 1 year ago
Commented on Bavarian Mask about 1 year ago
Update 13.04.2020 Version 1.02: ----------------------------------------------- - I created planned support für BavarianMask L to save material and print time. Modell is uploaded as BavarianMask_L_Supported.stl. (BavarianMask M / S / 2F will get planed support soon) - Some little changes on EasyClip, rounding the fixation.
Updated Bavarian Mask about 1 year ago
Commented on Bavarian Mask about 1 year ago
Update 12.04.2020 Version 1.01: ----------------------------------------------- - Cover is now 1mm higher to achieve tight fit of filterbox when using thicker cosmetic pads. It always works with thinner pads to push in the pressing ring wide enough. - Added the new EasyClip File. It’s smaller than the StrapClip, looks a little bit nicer and doesn’t need Support. - Added the source files for all BavarianMasks. Filterbox and Clips are only included in BavarianMask L. (Modelled in Fusion360)
Updated Bavarian Mask about 1 year ago
Updated Bavarian Mask about 1 year ago
Updated Bavarian Mask about 1 year ago
Updated Bavarian Mask about 1 year ago
Updated Bavarian Mask about 1 year ago
Updated Bavarian Mask about 1 year ago
Commented on Bavarian Mask about 1 year ago
Hello Rick, thanks for your comment. I don't like this support too. I'm testing with alternative strap slots, right now. The reason for actual design is, to get the Strap away from the face. There are some clinical circumstances for that. Hope to publish a new design soon. Next step is to make the cover about 1 mm higher. At actual version, a thick cosmetic pad could cause a gap between filterbox and mask. My Ultimaker is now printing some samples of height testing and a now EasyClip. Source files will be uploaded soon.