Activity
Updated Schmandbecher 3 months ago
Commented on Schmandbecher 4 months ago
There are changes on the way, the aileron-flags are created a bit smaller to fit bette rin to the glued wings, a new version of the elevator-flap is created, a servo-holder for the elevator-servo is created.
Updated Schmandbecher 4 months ago
Updated Schmandbecher 4 months ago
Published Schmandbecher 4 months ago
Published Pinselhalter - Brush Holder 4 months ago
Published XIAOMI WOWSTICK Stand 11 months ago
Commented on Tutorius-Cube - a makers cube over 1 year ago
https://www.youtube.com/watch?v=lWFpUd_kdlQ
A video of the print of this thing... The printer was not OK at this time, so the print had some holes and problems...
Published Tutorius-Cube - a makers cube over 1 year ago
Updated Spock-Hand - Live long and prosper over 1 year ago
Updated Spock-Hand - Live long and prosper over 1 year ago
Published Spock-Hand - Live long and prosper over 1 year ago
Published Dinosaur - 3D-Scan of Dinosaur Piggybank by "Meshlab" over 1 year ago
Commented on 1.75mm Filament Compatible Nozzle Clogging Prevention Oil Tank almost 2 years ago
What is the advantage of putting oil on your filament? For what printers is this recommended in your opinion?
Thanks a lot
Updated Casing for 3D-hardware MKS-(S)-GEN-L-Board almost 2 years ago
Published Casing for 3D-hardware MKS-(S)-GEN-L-Board almost 2 years ago
Updated Haltegriff - passenger assist handle - Renault Twingo 3 almost 2 years ago
Updated Haltegriff - passenger assist handle - Renault Twingo 3 almost 2 years ago