Cbe27b2e9e9fb1056d8b0c64ea2f63ef?default=blank&size=170

MvdW

  • Joined on Aug 24, 2014
  • Unknown
  • 16 times favorited
  • 1,469 times downloaded

Activity

Favored Z Nut for Simple 1403 almost 5 years ago
Favored M6 Handy Top almost 7 years ago
Favored Zip tie holder (parametric) almost 7 years ago
Favored DREMEL 4000 Table stand almost 7 years ago
Favored Clip Peg - General purpose almost 7 years ago
Favored Gyro Air almost 7 years ago
Favored Quick-print gear bearing almost 7 years ago
Favored Fingertangler almost 7 years ago
Favored Bag clip! almost 7 years ago
Favored Catan Boat almost 7 years ago
Favored Paper pawn stands almost 7 years ago
Favored Cable guard almost 7 years ago
Commented on Printrbot Simple Filament Spool Holder- No Aluminum Handle almost 7 years ago
<p>When printing this piece it starts to bend after a few layers and it gets partly loose from the bluetape (on a Printrbot Simple Metal with PLA) or it pulls the tape from the platform. <br></p><p>In the end I let the print finish and about 5mm from the platform there are now a few layers looking bad because the nozzle hit the plastic that was curled up a bit but this evens out after a few layers and then it went OK again.</p><p>Any tips on how to avoid this?</p>
Favored Filament Clip 3mm or 1.75mm almost 7 years ago
Favored Printrbot Simple Metal Dual Extruder almost 7 years ago
Favored Printrbot Simple Corner Accessory Mount almost 7 years ago