Excellent- I printed at .30mm ht. with 2 on the print bed. Took -hr 37 min. I increased the no of wall layers so there was no hatching on the arms. Making these for trial for a local medical office.
Feedback:
I’m going to print some snap on grommets to go over the studs on the outside so the clear shield won’t pop off.
Sorry, post should have read:
I have a .3mf file and gcode file for the Prusa MK3s, using generic PETG. It prints 2 mask holders on the print bed at .30 height in 1 hour 37 minutes. This is for the North America 6 hole version (punched twice with a 3 hole punch). Any use to anybody?
I have a .3mf file and gcode file for the Prusa MK3s, using generic PETG. It prints 2 mask holders on the print bed at .30 height in 1 hour 37 minutes. Any use to anybody?