×Read this message from Erik, founder of YouMagine
Span2 rabidscallion facing right 800x800

RabidScallion

  • Joined on Mar 28, 2020
  • Unknown

Activity

Commented on Protective Visor by 3DVerkstan about 2 years ago
Erik!!! I agree. You’re awesome! Credit all the way. Efforts goingTo in CT and NH (USA)
Favored Protective Visor by 3DVerkstan about 2 years ago
Commented on Protective Visor by 3DVerkstan about 2 years ago
@Andrew Normore Thanks so much for the guidance. Took my single print from 1.25 hrs down to 17 minutes. Also, Andrew is right, follow Erik's notes on printer settings. Using a 1.0 mm nozzle dramatic changed my print time and suffered very little in quality. Here is a run down on some basic settings in Cura that I've been using on my Ender 3 Pro 220x220 (no mods) Cura defaults for the most part with the following changes - No support - 1.0mm nozzle - 0.6 layer height - 2.4 Wall thickness (2 lines) - Concentric Top/Bottom pattern (thanks Andrew) - Fill gaps everywhere (nominal time difference and fills holes) - No infill - 210 Default printing temp (gets worse with lower temps for me) - Enable retraction with 8mm distance - 80mm/s print speed / 40mm/s wall speed / 30mm/s initial - Combing mode = All (helps with not having to clean up and no big change in time <1 min) In the middle of trying out @Icmyip stack print. I'll update to see how I do but my white filement needs a higher temp for some reason.
Commented on Protective Visor by 3DVerkstan about 2 years ago
This is great! Have you tested yet? I'm curious about optimizing the support and what settings you recommend.
Commented on Protective Visor by 3DVerkstan about 2 years ago
I'd LOOOOOVVEEEE to see a stacked version. It would be great to have someone figure this out. I'm babysitting my printer every 20 minutes to take one of the bed and get the other one printing. On another note though, I'd also like to see easy cleanup. Printing one a time makes it nice because I have little to no cleanup. Hopefully you guys can figure this out soon. I have one maybe two more printers on the way where I can print three on the same bed so if they're stacked even better so the bed & nozzle heat up time wont be a factor.
Commented on Protective Visor by 3DVerkstan about 2 years ago
Absolutely! You deserve it!!!
Commented on Protective Visor by 3DVerkstan about 2 years ago
THANK YOU SO VERY MUCH. What a great, light weight and comfortable design. Very fast compared to a lot of other designs. You should be proud. I want to circulate these to medical staff as soon as possible but want to make sure I respect your licensing and efforts. Do you require us to include the ReadMe.PDF when packaging to hospitals? These will all be donations.