×Read this message from Erik, founder of YouMagine
Fa04f9e01db6420132140e458353a822?default=blank&size=170

redheadmaker

  • Joined on Mar 27, 2020
  • Unknown

Activity

Commented on Protective Visor by 3DVerkstan about 2 years ago
@ErikCederberg, I know that, I have the file, I was asking @jenchris1
Commented on Protective Visor by 3DVerkstan about 2 years ago
Do you have the pdf with the template for the holes?
Commented on Protective Visor by 3DVerkstan about 2 years ago
The retrolabs version is a little further away from the face. It is very nice - just used the closedtop version, not the opentop. https://retrolabs.com/3d-prints/3d-printed-face-shield-with-10-mil-pvc
Commented on Protective Visor by 3DVerkstan over 2 years ago
Prusa slicer won't slice the Retrolabs stacked version. It says a empty layers detected and it is unprintable. I was able to print the separation test ok.
Commented on Protective Visor by 3DVerkstan over 2 years ago
I am using overhead transparencies and these work very well. You can find various ones on amazon. Try to find as thick as you can.
Commented on Protective Visor by 3DVerkstan over 2 years ago
The Prusa stacked visors come out just fine. Maybe someone can look at how they stacked them. I printed their four stack - which is two and two. Can't believe how much longer and how much more filament that one takes.
Commented on Protective Visor by 3DVerkstan over 2 years ago
The stack print doesn't work for me. I just used the bottom two on the stack and they pretty much came out fused together and when I chiseled them apart they are unusable. I guess for now I will stick with the two that are flat on the bed.
Commented on Protective Visor by 3DVerkstan over 2 years ago
Yes, I could slice this latest one. I will start it up before I go to bed. Thanks! I just gave 20 of these away to a firefighter friend of mine that said his house has 26 firefighters and only 6 face shields.
Commented on Protective Visor by 3DVerkstan over 2 years ago
That is ugly if I turn on supports. They aren't only in between. Prusa slicer supports are kind of a pain.
Commented on Protective Visor by 3DVerkstan over 2 years ago
Slicer won't slice the stacked file with 10, here is the error message: Empty layers detected, the output would not be printable. Object name: Visor_Frame_NORTH_AMERICA_LETTER_v3.3-stack10.stl Print z: 6.500000 This is usually caused by negligibly small extrusions or by a faulty model. Try to repair the model or change its orientation on the bed.
Commented on Protective Visor by 3DVerkstan over 2 years ago
Have you tried the stacked ones yet? How do they come apart? Do you end up needing to sand them?
Commented on Protective Visor by 3DVerkstan over 2 years ago
Does anyone have a stacked version of the U.S. visor?