Span2 reiner 001 2

Reiner Bühl

  • Joined on Sep 09, 2014
  • reiner@buehl.net
  • 76 times favorited
  • 12,644 times downloaded

Activity

Contributed on F26 UM2 Bearing Spool and Bearing Guide Upgrade 11 days ago
Carousel thumb 20210719 160049
Printed on:
Ultimaker - The Ultimaker 2
Result:
I modified the design to use 608 RS2 bearings and M8 hardware since I had those already. Thanks for providing the STEP files that allowed me to do so!
Feedback:
The base looked a little to weak for my taste. I used the one from https://www.youmagine.com/designs/low-friction-um2-spoolholder which fitted nicely as it also uses M8 hardware.
Commented on Hex Key Holder about 1 year ago
This design looks very elegant! Great work! Is it for metric size hex keys?
Published HomeMatic WLAN Gateway Case over 3 years ago
Updated ERSA MS 250 Solder Iron Switch over 3 years ago
Updated ERSA MS 250 Solder Iron Switch over 3 years ago
Published ERSA MS 250 Solder Iron Switch over 3 years ago
Published Case for miniCUL WiFi almost 4 years ago
Commented on Screw sorting tool about 4 years ago
Are the different trays for certain sizes? What types and sizes of screws does this work with?
Commented on Auto heatup script for Ultimakers almost 5 years ago
Is it sufficient to put that file (with the exact name) on the SD card or is there some other step needed?
Followed Izzy about 5 years ago
Commented on Flexbank Case about 5 years ago
Nice and very useful design! Do you have any advice for the print settings of the lid? Does it need support to print the top of the rubber band compartment correctly?
Commented on Ultimaker 2 Camera Mount over 5 years ago
Could you make STEP or Fusion360 files for this available? I would like to modify it for the standard Raspberry Pi camera and mounting via existing screws.
Commented on UM2 Heatsink Fan Duct Modified over 5 years ago
Today I tried to mount this fan duct on my UM2 but once it is installed, there is no room anymore to get the heater and temp sensor cables into the lower plastic part of the head. Is there another way to do this?
Commented on Belt Geared UM2 Feeder Upgrade over 5 years ago
One more question: Would F695 ball bearings also work as MF695 seem to be very hard to source?
Commented on Belt Geared UM2 Feeder Upgrade over 5 years ago
The GT2 pulleys are available in 5mm and 8mm bore versions. I assume both need to be 5mm versions, correct?
Commented on Sad Face! IMPORTANT NOTICE! over 5 years ago
If your item has always been licensed on Thingiverse as CC BY-NC-ND, then they are clearly violating your license and you should report your items within Ebay. If enough owners do that I would assume that Ebay will close him down.
Followed Santiago Calvo Ramos over 5 years ago
Commented on UM2 Print head top for 2.85+1.75 filaments over 5 years ago
Which feeder did you use for the 1.75mm side?