×Read this message from Erik, founder of YouMagine

Report inappropriate content

Charge controller holder + LED volt meter (solar)

For use with the Solar Charge Box https://www.youmagine.com/designs/solar-charge-box-v1


Assembly instructions:
- Print the two parts.
- Use the velcro to mount the solar charge controller on to the bottom box.
- Install the LED Volt meter in the volt meter printed box.
- Install the push button switch in the volt meter printed box.
- Solder the red (+) wire from the LED Volt meter to one terminal on the switch
- Solder a red wire to the other terminal on the switch
- Solder the other end of the red wire to the positive battery wire in the Charge Box unit.
- Solder the black (-) wire from the LED Volt meter to the negative wire in the Charge Box unit (add extra wire as required).
- Use the 4 screws to attached the LED volt meter box to the main charge controller box.
 - Push the switch, the LED Volt meter will display the battery voltage.
.

Your email is used to contact you if we need more information.


Back to design