×Read this message from Erik, founder of YouMagine

Report inappropriate content

Snowflake Ornaments - from the Snowflake Machine

These snowflake ornaments are about 50mm across and were generated with my Snowflake Machine:http://www.thingiverse.com/thing:1159436.

The models are optimized for printing on an Ultimaker 2 with ABS and 0.1mm layer height. If you want small snowflake ornaments that are already tested and ready to go, then print these.

But it's much more fun to go make your own, so go do that at the Snowflake machine link above! For 50mm snowflakes, set the "Target Diameter" to 50 in the "Global Size Settings". 

Your email is used to contact you if we need more information.


Back to design