Report inappropriate content

ColorFabb Cannon

Print off all the parts and connect together.
Everything is push - fit so not glue should be required. To get good details on the barrel i suggest to print with a small nozzle like 0.25 or 0.3 and low layer height like 0.06 or 0.8mm

Print list 
Bronzefill:
- Barrel x 1 
Corkfill: - Legs x 2 ( one needs to be mirrored ) - Wheel x 2 - Rear Brace x 1 - Front Brace x 1 - Wheel Retainer x 1 - Axil Pin x 2

Dark Grey
nGen or PLA:- Wheel Rim x 2 ( to be printed with 0.4mm nozzle no infill or top/bottm and spiralize turn on ) - Barrel Retainer x 2 - Barrel Adjuster x 1 ( has a small thread so low layer height and small nozzle recommended, Support roof 80% recommended ) - Adjuster Holder x 1 - Handle x 2 ( Support roof 80% recommended ) - Axil x 1 - Wheel Washer x 2 - Bolt - Short x 6 - Bolt - Long x 4

Your email is used to contact you if we need more information.


Back to design