Report inappropriate content

Volantex Ranger Ex / Quanum Observer Wings top plate camera mount

This is a plate that goes over the wings securing them to fuselage. I slightly modified design trying to reinforce it as 3D printed part will be weaker than original. Where level should be I have re-purposed this for camera mount, using 1/4" BSW 1/2" long screw.

I would suggest printing this in resistant filament (nylon, taulman alloy910). Also I think it is good to use wide washers under screws to spread out stress as evenly as possible.

Your email is used to contact you if we need more information.

Back to design