Report inappropriate content

BlueStack Micro Plus / DVMega Enclosure

This is a case designed to fit the BlueStack Micro Plus and DVMega Dual Band Raspberry Pi board (not sure if this will fit the mono band DVMega).

Print with PLA, .3mm Layer Height - I have been using 25% infill with .8mm shell.

Orient the main body so that the end opposite of the open end is on the build plate (orienting the whole thing on its end to minimize need for support). Support is recommended for filling in the corner that the antenna posts through.

Your email is used to contact you if we need more information.

Back to design