×Read this message from Erik, founder of YouMagine

Report inappropriate content

Snake

After printing the support should snap of easy by twisting it and the snake is fully functional. There will be a little support left in the ball joints but this will fall out by playing with it.

The file includes support that should work on more systems than my own. I print most of my stuff with these settings:
Layer height of 0.15 mm (If you want a really clean object, use less).
Outer walls speed 60 mm/s, infill 75 mm/s. Infill 25%,
bottom and top at 0.6 mm and walls of 0.5 mm thick.
I advise to use a brim to keep the 23 parts on the build platform until they connect.

It's a 51 cm (20 inch) friendly snake that doesn't bite or strangle, and it's free! I do appreciate feedback if you print it ;o)

Your email is used to contact you if we need more information.


Back to design