×Read this message from Erik, founder of YouMagine

Report inappropriate content

Rod Connector 90 Degree

Connector for perpendicular 12mm round rods or 10mm square rods.
Relatively solid construction.
Mostly parametric but optimized for implemented size.
Overall size is 50mm x 20mm x 20mm.
Comes with and without built-in supports.

Licensed under Creative Commons Attribution-ShareAlike: CC BY-SA
https://creativecommons.org/licenses/by-sa/4.0/

To assemble, take a saw and clean up the slot as well as the bridge.
Mount with 20mm M5 hex screws and M5 nuts.
Be careful to buy screws with an overall length of 20mm and not with a
20mm thread as these will be to long (as it can be seen in my pics).

Changelog:

020 : Slight fine tuning (see .scad for list)
017 : Added top and bottom phases (first version to release)
016 : Re-implemented support material
...

Your email is used to contact you if we need more information.


Back to design