Report inappropriate content

Side Table for IKEA Solvinden

I have create a side table to mount on an IKEA Solvinden solar powered floor LED lamp. Two versions are uploaded, one (dual1 and dual2) are targeted at dual extrusion machines, and the mono version is for a single extrusion machine.

The table can be mounted on the lamp by unscrewing the top rod. It rests on the knob between the two rods. The top plate is a little bit skewed and has water drain holes in the center.

I have only printed the dual version, so did not test the STL of the mono version. Any feedback is welcome.

Note: use the table at own risk, do not overload and be aware that PLA will degrade over time especially in outside conditions.


Your email is used to contact you if we need more information.

Back to design