Report inappropriate content

Sunshade for Epson Moverio BT300 and protective case

I made this shade to allow better view of the projected image in bright sunlight and as a protection for the glasses. Insert the glasses from the back. I printed this top down or standing on the back which needs much more support.

Printed this in PETG. ABS should be fine but PLA may be too stiff.

Added a case for the Moverio with attached sunshade so I can carry this around assembled.
In 4 parts as my print bed was too small. Glued together with epoxy. Needs 2x20mm M4 screws. New case version also holds the controller.

Your email is used to contact you if we need more information.


Back to design