Report inappropriate content

PTFE Spring/Spacer replacement with viewing-hole for UM2-series

A rigid spacer for the PTFE/TFM with a viewing hole where one can check that the bowden tube is properly seated.
This spacer can also replace the sometimes problematic spring on the UM2-machines.

I made the spacer 9.6 mm thick, compared to 9.4 mm for the rigid metal spacer on the UM2+, to compensate for bed-leveling inaccuracies.
This means that in normal cases there should be a small gap between the heat break and the block when tightened (see picture).

I recommend to use ABS, CPE or other materials that can take a bit more temperature than PLA for this print.
100% infill works best.

Your email is used to contact you if we need more information.


Back to design