Report inappropriate content

Spool holder for UP Plus / UP Plus 2 with bearings

Replacement filament spool holder for the UP Plus / UP Plus 2

Clips on instead of original one, filament spool rolls on skate bearings (608).

  1. Print holder (on the side) (100% infill, 5 perimeters)
  2. Print clip (holes up)
  3. Clean support
  4. slide 5-7 608 bearings on the middle rod (pay attention rod is fragile you can break it off if you are not careful)
  5. clip on the "clip" at the end of the holder
  6. clip the holder in place of original one

it holds easily 1.5kg spool of filament and spool rolls smoothly and quietly

source available on onshape

Your email is used to contact you if we need more information.


Back to design