×Read this message from Erik, founder of YouMagine

Report inappropriate content

3D printed RC truck V3: Center diff V2

Updated center differential for the V3 truck project!
More streamlined, less chance of getting stuck
Improved driveshaft angles, less chance to break the small shaft to gearbox
Higher gear ratio to get the RPM down

You can check out the other videos of this project at:

Hardware needed:
3x countersunk m3x10
2x M3x10
2x M3x16
4x 15x10x4 bearings

Check me out at:
Youtube: http://www.youtube.com/c/MrCrankyfaceProjects
Instagram: https://www.instagram.com/mr.crankyface/
3d hubs: https://www.3dhubs.com/malm%C3%B6/hubs/mrcrankyface

Your email is used to contact you if we need more information.

Back to design