×Read this message from Erik, founder of YouMagine

Report inappropriate content

USB 3.0 external Harddisk case for 15mm HDDs (for 3TB, 4TB, 6TB)

2.5 inch hard drives are very handy because they need only 5Volts from the USB port and no power supply unit. The largest and cheapest per gigabyte of these 2,5" drives come in 15mm Thickness and use more platters than normal 9.5, 12.5 or 7mm notebook HDDs.
Sadly there are almost no USB3.0 cases on the market which support these thicker 15mm Harddrives.

I recently bought a Seagate ST4000LM016 4TB drive for RAWs and video backups. I got the single 15mm enclosure which was on stock for it from Raidsonic icybox, but it would not work on my mac. Must have something to do with the controller raidsonic uses.
But a chinese 4$ noname USB3.0 case from ebay worked fine. The Case identifies with a USB ID of 0x0621 and a Vendor ID of 0x1f75 (Innostor Co, Ltd.).

Because the case only supported 12.5mm HDDs i made a new case to support 15mm drives. I decided to reuse the sturdy aluminium panels of the original external case and just print a new frame as this is most cost effective and has better looks and thermals compared to a pure 3d printed design. The case can be opened without any tools by pressing the front part and bending the hooks that engage the aluminium panels inside.
It took 4 design changes to get my idea and right, but the fifth print now fits perfectly.

Your email is used to contact you if we need more information.

Back to design