Report inappropriate content

Table support for headset

Hold headphones and its wire to the border or the table.

Print details:
Tested in PLA in 0.2mm layer:
- No small details so a 0.2mm layer high is ok (0.4 mm hotend)
- Since PLA is not very strong it is recommended >=25% infill that way the piece won't suffer if the screw is tight.
- No support needed
- I additionally used just a bit of "Pritt Multi Tack" to ensure the piece won't move because my table is quiet slippery (even though the screw is tight enough)

Your email is used to contact you if we need more information.


Back to design