Report inappropriate content

Tridom stand

3D models of the stand + left/right leg for the table game Tridom or Super Tridom. Made to print on a Prusa Mk2/Mk3, this replacement is 2cm shorter than the original. Just place the part and rotate 40 degrees to make it fit the build platform. The notches on the legs allow you to push them into the hole on the back of each board and they'll stay there. The legs come in two thicknesses so you can choose flush storage of legs, or slightly protruding (but easier to get out).

Your email is used to contact you if we need more information.


Back to design