Report inappropriate content

Guidler with Lever

It also has a little more material around the base of the guides and an M3 Nut-trap on both sides of the lever, so you can choose which way to put in the long screw - handy.

You may need the use of a hair-drier (30 seconds for PLA) or Hot-air gun for ABS to help it snap-fit into the slot if it's not a straightforward fit.

Heating printed objects is always a good trick for many parts that need to bend a little for assembly, especially ABS as it tends to want to break if you force it too hard.

Your email is used to contact you if we need more information.


Back to design