Report inappropriate content

Smart One Handed Bottle Opener

>>> THIS IS NOT INVENTED BY ME. THIS IS INVENTED BY MARK MANGER. I HIGHLY RECOMMEND TO VISIT GROPENER WEBSITE: "https://www.gropener.com/". THERE YOU CAN BUY THE ORIGINAL BOTTLE OPENER MADE IN ALUMINUM. <<<  

>>> GrOpener is the creation of Mark Manger, an Applied Artist from Denver, Colorado. Inspired by the stick & screw openers Mark encountered in Africa in the 1990′s, the GrOpener uses the same leverage principle, but in a form that allows a bottle to be opened through the act of grabbing it.  <<<  

Project video in Finnish (UPDATE: ENGLISH SUBTITLES AVAILABLE) (v.3.1): WITH SUPPORT MATERIAL (there is a little overhang!)

My first ever 3D creation!
Versio 4 (updated 23.6.14):
Now there is 4 different editions:
- Edition one: Basic OHBO
- Edition two: OHBO with magnet.
- Edition three: OHBO with a coin.
- Edition four: OHBO with magnet and a coin.
BTW: Other side (tail) of OHBO is meant to opening cans! (You can stick it under the clip)

Magnets from dx.com (here is a link: http://www.dx.com/p/10050078w-round-ndfeb-magnets-silver-50-pcs-239991)  

Coin is a basic 1cent euro coin.

You will also need some super glue if printing a Edition 2,3 or 4.

All editions are right scaled and tested. I recommend to print with 100% infill (layer height 0.2mm). My prints are PLA plastic but I think that ABS is even better because it is harder and stronger! I hope you to make one! I like to see how is your own bottle opener like!

visit: http://www.thingiverse.com/thing:269463

Your email is used to contact you if we need more information.


Back to design