Report inappropriate content

inBloom Dress by XYZ Workshop

If you like our designs, We would really appreicate if you are able to leave a tip Thank You!

The inBloom Dress was developed out of the desire to push the capabilities of what could be printed from an Ultimaker 3D printer using Flexible PLA filament.

Remember to activate Combine Everything Type A (Under Cura - Expert Settings - Fix Horrible) to get the best results.

Goto for instructions on how to make your own 3d printed dress

At its debut in New York the inBloom Dress was measured to be the longest 100% 3D printed dress at approximately 213 cm long. The dress is made of 191 panels, took 450 hours and 25 minutes to print and used 1.7 kg of 2.85 mm PLA Flexible. XYZ Workshop made an entire fashion suite available for download, which consists of the inBloom Dress, Flexible Watches, Women's Clutches and Men's Wallets.

    </div><p>More details here: <a target="_blank" rel="nofollow" href=""></a><br>Fashion Suite details: <a target="_blank" rel="nofollow" href=""></a></p><p><b>Full Fashion Suite<br></b>inBloom Dress: <a target="_blank" rel="nofollow" href=""></a><u><br></u>Flexible Watch: <a target="_blank" rel="nofollow" href=""></a><u><br></u>Women's Clutch: <a target="_blank" rel="nofollow" href=""></a><u><br></u>Men's Wallet: <a target="_blank" rel="nofollow" href=""></a></p><p><b></b><b>Ultimaker Story<br></b><a target="_blank" rel="nofollow" href="

Photography Credits

Dress design XYZ Workshop

3D printed on Ultimaker 2 and Ultimaker Original

Photography Fanny van Poppel

Make-up and hair Danielle Trilsbeek

Model Awisa

Your email is used to contact you if we need more information.

Back to design