Report inappropriate content

Filament Dispenser Mount V2

This is a redesign of Koolman's original part. The original design had a few issues that caused the buildplate to foul the mount. The fit inside the panel was also very tight. Koolman was able to fix these with some sanding, but I decided to redesign it because it was quick enough for me to do.

I made the following changes:

• Made the countersink for the screws larger, so the heads were flush with the mount.
• Loosened the hole clearance for the screws. (6mm to 6.4mm diameter)
• Reduced the thickness of the back from 5mm to 4mm.
• Made the parts that are inserted into the panel smaller so the fit wasn't so tight. (now a 0.25mm clearance according to the Ultimaker STEP file for the back panel)