Report inappropriate content

Remix of Protective Visor by 3DVerkstan - for Single extruder stacking

Thanks to the original designer Erik Cederberg at 3DVerkstan.

This is a two piece design to allow single extruder stacking, using a 45 degree taper down to a line, to make separation possible without any support materials or fine tuned settings. The cover part is separated from the frame so that no bridging is needed.

Separation can be a bit tricky and takes about a minute per piece, but allowing overnight printing will probably make up for that.

Only the Swedish 4 hole version is available at the moment.

Your email is used to contact you if we need more information.


Back to design