Report inappropriate content

Printable Hand Vise

When working with small models sometimes my fingers just are too big. So I made a fully printable hand vise.

Print everything in PLA with a layer height of 0.2mm or lower. Support is not needed. The thread is close to M12 and should work directly after printing. Lubricating the thread is recommended - I am using candle wax for that. If you want, you can re-cut the thread with an M12 tapper, but that should not be necessary.
For the hinges I designed hinge rivets. To install the claws insert the claws and the hinge rivets, heat up a screwdriver and press it on the small end of the rivet. The rivet will melt in place.

Your email is used to contact you if we need more information.

Back to design