Report inappropriate content

[V2] Cycling Computer Mounting Bracket

This updated version of my cycling computer mount allows you to place your cycling computer in line and in front of your stem. Instead of using the provided rubber band, I glued the mount that came with the cycling computer in place using some two-part epoxy. Note that your cycling computer mount must be a 33mm octagon (from one flat side to the opposing flat side), otherwise this mount won't work.

Compatible with a standard 31.8mm handlebar. A link for the specific cycling computer I use, can be found below. Other cycling computers with a similar mounting mechanism will most likely work just fine too. Besides the two-part epoxy, you'll need a short M3 screw (around 6mm) and M3 nut for assembly.

M3 hardware:
https://bit.ly/2V1DD0k

Cycling computer:
https://bit.ly/2NiBVDK

Support
If you want to support me for the designs I publish for free, please consider using my AliExpress Affiliate Link (https://bit.ly/2XYWpHW) when buying something from AliExpress. It doesn't cost you anything extra, but helps me out a lot :)

This post contains affiliate links

Your email is used to contact you if we need more information.


Back to design