Report inappropriate content

120mm Honeycomb Fan Duct (2 Piece)

This 2 piece fan duct can be used to limit/direct the direction from which air is sucked into the fans or blown out. Once the fan plate and fan duct are printed, they can be glued togehter. I used super glue, which works fine.

You could try printing the fan duct without support, but that will most likely result in ugly fillets. Therefore, I would suggest using 'supports from build plate only' function within your slicer.

Support

If you want to support me for the designs I publish for free, please consider using my AliExpress Affiliate Link: https://bit.ly/2LPMNMh when buying something from AliExpress. It doesn't cost you anything extra, but helps me out a lot :)

Your email is used to contact you if we need more information.


Back to design